Simple Sew Kaftan top & dress

Summer is (allegedly) on it’s way at last and so my sewing thoughts turn to summery frocks. On that optimistic basis I decided on the Kaftan top and dress as my next Simple Sew blogger review and this time we have Doughty’s Online as one of our generous fabric sponsors too. I have to confess I wasn’t familiar with them but when I checked out their website I was very impressed with their wide selection of fabrics available. I chose this beautiful digitally-printed cotton lawn by Lady McElroy fabrics in a design called ‘Scottish Emblem’ and it’s lovely quality, similar to Liberty Tana lawn I’d say.

Before I cut into the lawn I decided to make the top version in some georgette that was languishing in my stash. I’d bought it ages ago in the Birmingham Rag Market without a project in mind, I wrote post about that visit which you can read here.

I’ve made my last few Simple Sew makes in size 14 based on my measurements and this one was no different. Georgette is quite wiggly so my advice is to take your time laying it up, tear the cut ends to get a really straight edge and use the edges of the table to give you a visual ‘marker’ to lay the fabric up as straight as possible. You can even layer it between spot-and-cross paper but that’s longwinded and uses up your paper. Georgette is also sheer and frays quite badly so I used French seams throughout. The pattern calls for bias binding on the neckline and sleeves but that would be too heavy on georgette so I simply pin-hemmed them instead.

This revealed a bit of an issue with the depth of the V!

Crumbs! I’ll need a vest under this!

It all went a bit pair-shaped at this point because I got in a right two-and-eight with the buttonholes and the casing for the waist. I wasn’t happy with the position I sewed the buttonholes (according to the pattern) although in the end after a lot of messing about I left them where they were and made the casing wider around them but narrower for the rest. I found the instructions a bit confusing so I urge you to take each stage carefully and take into consideration how wide your ribbon/cord/elastic is when making the buttonhole openings and make the channel only as wide or narrow as you need it to be, not necessarily the width marked on the pattern.

Once I was happy with this first version I went ahead and cut out the full-length one in my lovely cotton lawn. It has a large repeat which is a one way design although not with an obvious up or down-in other words, everything must be cut going the same way but it didn’t matter which way that is. Just before I cut it I noticed when I placed the CB bodice on the fold that the neck edge isn’t quite ’true’ which would result in a slight point in the centre of the neck. It isn’t difficult to correct this.

If you don’t have a Patternmaster use something with a right-angle corner like this envelope to straighten up the line.

the new line is where you need to cut.

One other change I made before I cut was to raise up the V so it wouldn’t be as revealing as the georgette one!

Stick an extra piece of paper behind matching the CF line with a new line on the paper behind. Stick it down with tape.

Decide how much you want to raise the V and draw in a new line so that it blends smoothly with the original.

There’s a seam in the centre front so mark the seam allowance with a notch

The back goes on the fold and the front can go against the selvedge, the same way up in this case.

Because the fabric is a one-way design I needed to cut each skirt piece one above the other instead of interlocking them. Instead of simply folding the fabric in half and wasting two strips down each edge I folded it like this and then there’s useable piece left for something else!

It was just a case of putting everything together like before, the difference this time is that I added self-fabric bias binding to the neck, I also stay-stitched the neck edges to prevent them stretching before I sewed the bias on. First join the shoulder seams then…

I cut a strip of bias binding which I folded and pressed in half lengthways first. For this method place the it with cut edges matching on the WRONG SIDE of the fabric, sew on with a 5mm seam allowance.

Trim the seam down to 2-3mm

Press the seam towards the bias, the second row of stitching you can see is the stay-stitching.

Turn the bias to the RIGHT SIDE and stitch carefully and neatly close to the edge like this. Now you can join the CF seam together. I learned that this technique is called French binding which I never knew before-every day is a day in school!

Before I joined the under arm seams I added some lovely pom-poms which I’d bought in Liberty especially.

I sewed it on using a zigzag stitch because it’s difficult to get close as the pom-poms get in the way. You could probably use a straight stitch and a zip foot here too.

I cut the pom-poms carefully so that there wouldn’t be one caught in the seam.

The reverse of the pom-poms

I added a fancy leaf design stitch on my Pfaff to edge it with.

I tried the bodice on and decided that the neck needed the pom-pom trim too, I wasn’t originally going to put it here but the neckline looked a bit plain against my pasty white skin!

 

I pinned it on in two different ways and eventually settled on just around the V

Because I’d bought a very narrow cord to put around the waist I made very small horizontal round-ended buttonholes instead of the larger vertical ones indicated on the pattern. Attach the skirt and make the casing for the cord according to the instructions and you’re almost there.

I pulled the cord through using a useful old-fashioned tool called a bodkin. Clamp the cord (or elastic) between the ‘teeth’ at the end and slide the small metal loop up towards the teeth until it’s tight and the cord can’t come loose. Then you just push the cord through the channel.

I opted to leave a knee-high split in one of the side seams. The sun came out so Doris posed outside!

The jazzy orange cord came from McCullough & Wallis in London.

I eventually finished the georgette version too, I used a shoelace from an old pair of my husband’s shoes in the casing because it was a perfect colour-match! I cut off the ends and embellished them with a few colourful buttons.

 

 

 

I hemmed this one by using the rolled hem setting on my overlocker. It definitely needs a vest under it though!

The kaftan will be a lovely cover-up on holiday in the summer and as I chose the cotton lawn it will be decent enough to go out in public and not just by the pool on hot days too! It would work well in a drapey viscose or look glamorous in a slinky crepe de chine, or a lightweight jersey like interlock. The short version would look nice in a Broderie Anglaise or Swiss Dot too. Instead of the pom-poms you could embellish it using Indian or Chinese-type braid, ribbon or even beading, you could put elastic through the casing too instead of cord or ribbon.

Thank you especially to our new fabric partners Doughty’s Online for supplying my choice of cotton lawn, it’s been lovely to work with and I’m looking forward to being able to wear it…soon, I hope!

Happy Sewing,

Sue