It’s been a while since I wrote my first blog post for Backstitch way back in January but I’m happy to say that I have loved wearing the Ellsworth shirt I made then, it’s been a great addition to my wardrobe.
For my second post I’ve sewn a Homer and Howells Ingrid dress. Like many popular styles circulating this year it’s a loose-fitting dress but the USP of the Ingrid is its unusual asymmetric style lines.
The front and back are both quartered by differing horizontal and diagonal seams, plus the bust shaping is in the form of tucks in the centre front seam. It pops on over the head so no zips to insert, there are inseam pockets and a choice of two skirt lengths and two sleeve shapes.
I felt with all this unusual seaming going on that I didn’t want a busy printed fabric which disguised it (that said, you could have fun with stripes or even checks) My original plan was to use needlecord and deliberately cut the pieces in opposite directions to highlight the shading this would create.
However I wasn’t sure that any of the colours available in the shop at the time I was making it were really very ‘me’ so I plumped for the saffron yellow Broderie Anglaise double gauze instead! [I made this handbrake turn decision partly based on having recently seen a woman wearing a similar style RTW dress made in grey Broderie Anglaise and the fabric looked great, not too ‘girly’ or twee at all]
The stitching on Broderie Anglaise fabric usually has a right and a wrong side if you look closely at the embroidery but it isn’t always very obvious. My advice would be to choose the side you prefer and stick to it throughout! Because virtually every piece of the Ingrid is cut as a single I pinned paper labels onto each one so that I didn’t get them mixed up. Alternatively you could use small sticky dots to differentiate.
I gave the fabric a pre-wash before cutting, there was virtually no dye run and no obvious shrinkage either. Because of its asymmetric shape the Ingrid is almost all cut from a single layer of fabric so I would highly recommend keeping each pattern piece attached to the fabric until you’re ready to use them, or label them as I’ve suggested earlier. [Incidentally, if ever you’re short of fabric for a project, check if you can cut it out of a single layer rather than folded, it’s always more economical…just make sure you mirror everything as necessary] Helpfully Backstitch sell their fabrics in 25cm increments which can mean a lot less wastage, I bought 2m25 for this dress.
I found the instructions and diagrams for construction nice and clear and very straightforward, do read them through a couple of times first though because I made assumptions about the order of making in a couple of places which would have led me up the garden path and some unpicking. The right and left dress parts are sewn tops to skirts before joining vertically at the centre front and back. Some of the seams which would normally match one another on more conventional styles don’t on the Ingrid because of the asymmetry but if you start pinning at the top of each seam down to the hem you should be fine.
The fabric sewed up nicely although be aware that the weave of double gauze causes it to have a little inherent stretch so try not to pull it about too much during construction, and pressing causes some of the natural crinkles of the cloth to flatten as well but they will bounce back after the next wash.
I made a couple of other small deviations from the pattern by using self-fabric bias binding instead of the neck facing. I cut a bias strip 4cms wide, folded and pressed it lengthwise before sewing the two cut edges to the neckline on the dress. Next, I understitched the seam to the inside then finally topstitched it down to finish. I also chose to sew my own thread loop for the button at the back neck rather than try to make a rouleau loop with such ‘bobbly’ fabric, I was delighted to find a button in the shop which is a great match to the fabric colour.
I wasn’t convinced that either skirt length would be quite right on me so I went somewhere in between, finishing a little below knee length (I’m 5’5”) I wanted longer sleeves too so I used a bell-shaped pattern with a cuff which I had drafted myself for a different dress earlier in the year.
Finally, I turned up the hem by 2.5cms and then used one of the huge range of embroidery stitches on my Pfaff machine to sew it up, it took a while to go all the way around the hem but I love the little detail it gives.
The only fitting change I will probably make if/when I sew another Ingrid is to slightly reduce the width of the shoulders, the sleeves cause them to droop off my shoulders a little but it’s not a major issue. I sewed the UK14 with no fitting adjustments other than the length and it’s very comfortable.
Thank you to Backstitch for providing me with the fabric and supplies to sew with by means of gift vouchers, the Ingrid is not currently stocked in the shop though. Broderie Anglaise might not be typical winter fabric but I love the sunny colour on a miserable English day.
I hope you’ve found my review helpful, until next time,
One thought on “My latest Backstitch project, the Ingrid dress by Homer and Howells”
Such a great dress! And a wonderful timely review – I just discovered the H+H Ingrid pattern yesterday and I am now even more enthusiastic!
LikeLiked by 1 person